What to Ask Before an OEM CAT6 EtherCon RJ45 Cable Order?

An RJ45 plug isn’t a stage connector. The latch snaps off in a road case, the boot works back after a hundred strikes, and the pair order inside the cable matters more than anyone says out loud. The one we keep on the shelf is a CAT6 EtherCon RJ45 cable, and it’s stocked in six lengths from ten feet up to a hundred and fifty. If you’re running a digital snake, a lighting rig or a video feed over copper, most of what goes wrong has already gone wrong at the plug, so that’s where this starts.

What EtherCon actually protects

The shell is the point. A bare RJ45 has a plastic latch that sticks out and catches on everything else in the case. Put a metal shell around it and the latch sits inside a housing that takes the knock instead. That’s the whole idea, and it’s why these get specified for touring work. Ours is EtherCon compatible, so it seats in the panel connectors you’d already have on a stage box or a fixture. If your gear specifies the branded shell, tell us on the enquiry and we’ll match it rather than assume.

RJ45 audio snake cable

Four pairs, seven strands each

The conductor is oxygen free copper, and the build is four pairs of two conductors. Each conductor is seven strands of 0.19 mm with 1.0 mm of polyethylene over it, and there’s a drain wire of seven strands of 0.12 mm bare copper alongside. You can read all of that off the sheet as [(7*0.19+PE1.0)*2C]*4P+DW7*0.12BC, and it tells you two things. The stranding keeps the cable flexible enough to coil every night, and the insulation is what holds the pair geometry CAT6 depends on. Cheaper cable gets you solid cores that work fine inside a wall and crack after a season in a truck.

Mylar first, then the braid

Shielding here is two layers. Aluminium mylar goes on first, then a braid built from sixteen carriers of five 0.1 mm strands over the top of it. The foil catches the high frequency mess and the braid does the low frequency work, and the braid is what the drain wire sits against. On a stage you’ll have lighting cable and power running alongside, and this is what keeps the data clean through it. It’s also what stops the network cable being the thing the engineer blames when a fixture drops out.

If you already know the lengths you need, you can skip the rest and go straight to the contact page on our site. Most of what follows is about what goes wrong after the cable is bought, and you may not need it.

audio snake cable

Eight point two millimetres of jacket

The jacket is PVC at 8.2 mm outside diameter. That’s thicker than anything going into a wall, and it’s deliberate, because this cable gets walked on, rolled over by cases and coiled while it’s still wet. PVC stays flexible in the cold, which matters when your truck unloads in a northern car park in February. A cable that’s been coiled and uncoiled for a season will outlast the gaffer tape that held it down. Yinyu stands get the same rough treatment in a rental store, and we build both with that in mind. If you need a different jacket for a fixed install, tell us the environment and we’ll say what we can do.

Lengths we keep on the shelf

The stocked lengths are ten, twenty, thirty, fifty, one hundred and one hundred and fifty feet. Those six cover most of what a rental house orders, and they’re the ones that are ready to ship when the order lands. Anything outside them is a build, and that isn’t a problem, it just isn’t instant. If you want a length that isn’t on the list, printed on the jacket and on the carton, that’s an OEM job and we do plenty of it. The RJ45 CAT6 snake cable is built to the same conductor and shield, just with more channels in one jacket.

There’s a reason the short ones sell fastest. Ten and twenty foot lengths disappear between a stage box and a rack, and they’re the ones that get borrowed and never come back. A rental house that orders by the case usually takes a mix, and we’d rather you told us the mix than got six of the same.

Where the latch breaks

Ask anyone who’s opened a case on a Monday. The failures sit at the plug, not in the cable. The latch snaps, the boot slides back and the strain relief stops relieving, then the pairs take the pull and the link falls to a hundred megabits or drops altogether. A moulded boot with a shell over it is what prevents it. If you’ve ever taped an RJ45 down so the latch would stop catching on the Yinyu stands packed beside it, you already know this and you don’t need telling.

audio snake cable

Testing before it goes in the bag

Every one gets a continuity check per pair before it’s packed, and the ones with shells get seated and pulled a few times to confirm the latch still springs back. It isn’t clever. It’s just the test that catches what actually fails. After that the cable goes into a PE bag and a brown box. If you want your own print on the bag or the carton, that’s available, and it’s the sort of thing that belongs in the first email rather than in a note after the deposit.

Art Net, sACN and Dante in one run

People ask whether one cable can carry lighting and audio, and the answer depends on what you’re sending. Dante, AVB, sACN and Art Net all run over the same copper, and in plenty of small rigs they share a run. For a house doing both, the CAT6 build and the shielding are the same job. What changes is the length. A hundred and fifty foot run to the far end of a stage is different work from twenty feet across a drum riser, and if you’re near the top of the range we’d talk about it before you buy.

The other thing that catches people is the patch panel on the far end. A run is only as good as the connector it lands in, and a cable with a good shield on it doesn’t help if it terminates into a jack that’s been kicked loose in a rack for two years. If you’re specifying a whole run, tell us what’s at both ends.

What travels beside it

Cable orders rarely come in alone. A drum of Ethernet going out will often have a multichannel XLR audio snake cable next to it, or a multichannel XLR audio snake cable built to the same lengths. Yinyu cables cover all of that, and they come off the same shelves. Yinyu stands go into the same purchase orders, because the stage box still has to sit on something. Audfine headphones turn up too, which surprises people until they remember it’s one loading dock. It’s all built in the same works by Ningbo Lesound Electronics, and one booking covers it.

audio snake cable

Before you order

Four things and we can usually pull it the same week.

  • The lengths, and whether they’re stocked or built
  • Whether you want EtherCon compatible shells at both ends
  • What runs over it: audio, lighting, video, or all three
  • Whether the bag and the carton need your print

The last two are the ones people forget, and they’re the ones that decide whether a pallet ships this week or waits. If you’d rather not fill anything in, send a list of lengths and we’ll come back with what’s on the shelf. For a long run that gets coiled every night, ask about the RJ45 cable drum reel instead of the bag, because it changes how the truck gets loaded.

Questions about a CAT6 run

Does it work for Dante?

It does. It’s CAT6 with all four pairs and a drain wire bonded across them, which is the sort of cable Dante runs on. People sometimes ask whether they need a special cable for it, and they don’t. They need a decent one, which is a different thing entirely.

Is the shell the real EtherCon one?

It’s EtherCon compatible, which means it seats in the panel connectors you’d expect it to. We don’t supply it as the branded original. If your gear specifies that shell, tell us and we’ll say what we can fit.

Can I get 150 ft in one piece?

You can, and it’s one of the lengths we hold. Past that you’d be pushing what copper is happy doing without a switch in the middle, and we’d rather tell you that than sell you a run that drops packets at the far end.

Will it carry power too?

The cable will pass it, but this build isn’t rated or sold for power over Ethernet, and we won’t sell it as one. If you need PoE for a fixture or a camera, tell us at the enquiry and we’ll talk about the build that needs.

Do you print our length on it?

We can print your part number, your length and your name on the jacket, and put your artwork on the bag and the carton. It’s an OEM job and we do a lot of it. It also adds time, so it belongs in the first email.

How fast can it ship?

The six stocked lengths are ready to ship and go out on the next booking. Anything outside those is a build, and we’ll give you a date rather than a guess. We don’t publish lead times because they move, so ask and we’ll tell you where it stands that week.

A network cable is the cheapest thing in a rig and the first thing everyone blames. Buy one built to be coiled, walked on and pulled out of a case in the dark, and it stops being a line on the fault list. Put CAT6 EtherCon in the message and it’ll reach the right desk. Otherwise the contact page on our site is the quickest way in.


Post time: Nov-12-2026
+86 13780007246