News
-
Looking for a Reliable Custom Speaker Driver Manufacturer for Heavy Bass?
There is no worse feeling for a sound engineer or mobile DJ than hearing a loud pop, followed by the sudden silence of a blown subwoofer. The p...Read more -
Looking for a Reliable Boom Mic Stand Manufacturer for Heavy Mics?
If you work in audio sales or run a recording studio, you’ve seen it happen. A client mounts an expensive, heavy condenser microphone onto a ...Read more -
Is a 21 Inch Subwoofer the Right OEM Driver for a Touring Box?
A twenty one inch woofer changes things before it makes a sound. The crate gets bigger, the pallet count drops, and the freight line on your quote moves. We keep seeing the same sequence. A cabinet builder runs an eighteen for a few years, gets asked for more low end in a tighter footprint, and s...Read more -
Does a Powercon Combo Cable Beat Separate Power and Signal Runs?
A club in Rotterdam re-rigged its truss last spring and cut its cable count by a third. Power and DMX used to travel on separate runs, which meant two coils per truss position, two bundle ties, and a load in time that everybody complained about. The new looms carry both in one jacket. Six weeks l...Read more -
Why Does Your Heavy Mic Sag on a Boom Mic Stand? (MS005T Fix)
If a heavy microphone slowly drops toward the floor after you tighten the boom arm, the problem is usually not your clamping technique. It is the joint. A Microphone Stand that can...Read more -
Do Speaker Isolation Platforms Fix a Boomy Nearfield Mix?
Somebody mixes a track on a desk, plays it in a car, and the low end has vanished. They blame the room, then the monitors, then themselves. Nine times out of ten the problem started at the desk surface, because a wooden top under a pair of speakers doesn’t sit still. It moves with the cabin...Read more -
Heavy Mic Drooping Again? Which China Tripod Mic Stand Factory Uses Metal Boom Clutches, Aluminum Bases, and Ready-to-Ship Stock for OEM Buyers?
A pro audio dealer once sent us a short message: “Customer’s large condenser will not stay put on the boom. Is the mic too heavy, or is the stand too weak?” Most of the time, i...Read more -
Need an RJ45 to XLR Adapter Supplier in China with OEM Support?
A studio in Leeds put a wall plate in the live room last winter. Four microphone lines, one network cable back to the rack, and a small metal box at each end to turn the RJ45 into XLR again. It worked for four months. Then a freelance engineer patched his own leads in and found channel two arrivi...Read more -
Shopping for a Folding DJ Booth That Won’t Wobble by Gig Three?
A lot of folding DJ tables get returned for the same reason. The first event goes fine. By the third or fourth load-in, a hinge has play, the table rocks when someone leans on it, ...Read more