Application Guide

  • DMX Cable vs XLR Cable: They Look the Same, They Are Not

    DMX Cable vs XLR Cable: They Look the Same, They Are Not

    Walk down the back line of any stage and you will see two cable types that are almost impossible to tell apart at a glance. Both use the same latching XLR connectors, both wear a round black jacket, and both coil up into the same road trunk. One carries the audio from a mixing console to the ampl...
    Read more
  • Patch Cables for Pedalboards: Flat Plug vs Straight Plug

    Patch Cables for Pedalboards: Flat Plug vs Straight Plug

    Ask five guitarists what makes a pedalboard quiet and tidy, and four of them will talk about the pedals. The fifth — the one whose board never buzzes and whose cables never tug loose mid-set — will talk about the patch cables. On a pedalboard, the cable is not an accessory; it is the plumbing tha...
    Read more
  • Looking for a Double X Keyboard Stand Manufacturer in China?

    Looking for a Double X Keyboard Stand Manufacturer in China?

    A keyboard stand is a few metres of tube and a pin until somebody leans on the end of it at a soundcheck. Ask two factories for the same double X keyboard stand and you’ll get two frames that look identical in a photo and behave differently within a month. The difference hides in three plac...
    Read more
  • Which Piano Bench Should You Stock This Season?

    Which Piano Bench Should You Stock This Season?

    A piano bench looks like the simplest line on a dealer’s order sheet until the first complaint arrives. A bench that folds flat for a van and a bench that stays set up in a teaching room answer two different questions, and the cost of choosing wrong shows up a season later, when a school ri...
    Read more
  • Soldered vs Molded Connectors on Pro Audio Cables

    Soldered vs Molded Connectors on Pro Audio Cables

    Ask two buyers why their cable orders look different, and the answer often comes down to one detail that never appears on a product page: how the wire is terminated inside the plug. A soldered, assembly-type connector and a factory-molded connector can carry the same signal and look similar from ...
    Read more
  • Cable Gauge and Length: How Much Signal Do You Actually Lose

    Cable Gauge and Length: How Much Signal Do You Actually Lose

    Every amplifier sends its hardest job down two pieces of copper. Unlike the line-level signals that travel between a mixer and a processor, a speaker feed carries real current, and any resistance in the run sits directly in series with the driver. Gauge and length are the two variables that decid...
    Read more
  • How Do You Choose a Reliable Conductor Music Stand Supplier?

    How Do You Choose a Reliable Conductor Music Stand Supplier?

    A conductor desk is judged by sixty people at once. It has to hold a bound score open with no hand on it, sit at the height of someone who’s standing, and survive a car boot every week of the season. Most stands that disappoint a buyer fail on the first of those three, because the desk is t...
    Read more
  • Guitar Stand Types and When Each One Makes Sense

    Guitar Stand Types and When Each One Makes Sense

    A guitar stand looks like the simplest piece of gear in a studio or on a stage, and that is exactly why it is so often chosen badly. A stand that suits a touring electric player may be awkward in a teaching studio. A rack built for a retail wall is overkill for a bedroom practice corner. At LESOU...
    Read more
  • Which Drum Throne Weight Rating Should You Trust Before a Stage Order?

    Which Drum Throne Weight Rating Should You Trust Before a Stage Order?

    A drum throne gets ordered the way drum hardware usually gets ordered. Somebody in the shop points at a photograph, gives a weight figure off the top of their head, and a pallet turns up six weeks later. The weight figure is where most of the trouble starts, because the number a drummer quotes an...
    Read more
+86 13780007246